Step-by-Step Usage Guide
Step 1 Adjust the silicone exposure height (Unique Adjustable Function)
Twist the bottom round base and pull the middle plunger up/down to change how much silicone head sticks out:
- Shorten exposed silicone for small-size stamp patterns
- Lengthen exposed silicone for large full-nail designs
Lock the height by tightening the base after adjustment.
Step 2 Fill stamping polish on the steel plate
- Apply a thick layer of special nail stamping polish over the engraved pattern on the stainless steel plate.
- Hold the scraper at a 45° angle, scrape excess polish off the plate in one smooth stroke, leaving polish only inside the engraved grooves.
Step 3 Pick up pattern from the plate
Hold the stamper handle, press the silicone head straight down vertically onto the engraved pattern gently. Keep pressed for 1–2 seconds so polish fully transfers onto the silicone surface.
Tip: Clean residual polish/dust on silicone with adhesive tape to avoid incomplete pattern pickup.
Step 4 Transfer pattern onto nail surface
Ensure your nail base coat is fully dried first. Press the patterned silicone vertically down onto your nail in one even roll to stamp the complete design onto the nail plate.
Maintenance & Notes
- Do not use acetone or strong remover to clean silicone head; use scotch tape to remove leftover polish.
- Store the stamper in a cool dry place to avoid silicone deformation from high temperature.
- If pattern cannot transfer cleanly, check polish thickness or silicone surface cleanliness first.
Reviews
There are no reviews yet.